Video tutorial category B:

Vehicles with pollen filter in front of the blower motor

Videos on YouTube

When you view and play embedded videos on aircowell.com, the provider (YouTube) may be able to store your access and analyze your behavior. If you activate the content, i.e. agree to view and play it, a cookie is placed on your computer to record that you have agreed to this in your browser. This cookie does not store any personal data.

For more information, please see our privacy policy and cookie page.

You can also use this link to access the video directly on the plattform of the provider: https://youtu.be/MTL7vPDYcks

 

Step-by-step tutorial

  • Place the drip tray under the condensation drain (➜ Fig. 1).
  • Cover the footwell in the passenger area with floor protection (➜ Fig. 2).
  • Remove the blower motor (➜ Fig. 3).
  • Guide the probe through the air duct to the evaporator (➜ Fig. 4) - if necessary, adjust the probe by carefully bending it.
  • Fill the complete 994 contents into the pressure cup gun and connect on the air side.
  • Place thumb on the guide disk (fixing the spraying direction (➜ Fig. 5) and perform spray test (➜ Fig. 6).ATTENTION: Ensure correct spraying direction and check whether the liquid flows off via the drain into the collecting tray.
  • Operate the pressure cup gun and flush the evaporator with the complete contents of the pressure cup gun by moving the probe back and forth (➜ Fig. 7).
  • Reinstall blower motor
  • Remove cabin air filter and remove coarse debris such as leaves from the ventilation system.
  • Spray out the pollen filter box completely with 996 (➜ Fig. 10).
  • Wipe the pollen filter box completely dry with the microfiber cleaning cloth (➜ Fig. 11).
  • Insert the new cabin air filter (not included in the set) (➜ Fig. 12).
  • Fill out the mirror tag according to the services and hang it in the cleaned vehicle.

Images

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 10
Figure 11
Figure 12

Important notes

  • CAUTION: When cleaning high-voltage vehicles (BEV and hybrid), the following points must be observed: Work on high-voltage vehicles may only be carried out by authorized and instructed employees with a certificate of competence (observe national regulations). Before starting work, high-voltage vehicles must be disconnected from the power supply by authorized personnel in accordance with the manufacturer's specifications. If this is not done, there is a risk of serious damage to health and damage to the vehicle. Before starting work, high-voltage vehicles must be de-energized by authorized personnel in accordance with the manufacturer's specifications. Failure to do so may result in serious health hazards and damage to the vehicle!
  • WARNING! Protect electronic components located in the cleaning area reliably against moisture!
  • CAUTION! Avoid contact of the evaporator fins with the metal probe.
  • If necessary, the metal probe can be adjusted by carefully bending it.
  • Cleaning with airco well® does not require any rinsing, e.g. with water!
  • Lubricate the thread of the pressure cup and the air control piston behind the actuating lever with silicone grease (e.g. TUNAP Human Technologie 907 or MP 107) after each cleaning.
  • It is recommended to wear protective equipment (PPE) such as goggles, mask and gloves during use.